Flightgear radio not working11/14/2023 ![]() ![]() 723.340 MHz: French Air Patrol communication frequency.Depending on the FGCom server in use, a recorded radio message will be played 121.000 MHz, 121.500 MHz: "guard" frequencies reserved for emergency communications.NotesįGCom understands several special frequencies used for testing purposes or general chatting: Exit Statusįgcom exits with EXIT_SUCCESS on success, with EXIT_FAILURE if the syntax of the command-line arguments is wrong or an error occurs. versionĭisplay the FGCom version and exit. debugĮnable debug output for troubleshooting purposes. Setting the silence threshold to -60 turns the filter off setting it to 0 filters everything (mutes the microphone). The silence threshold is the level below which the sound captured by the microphone is considered background noise (and, thus, filtered out by FGCom). Set the silence threshold to threshold dB. Log in to the FGCom server using the username user and the password pass. Always use this flag if you are not connecting a FlightGear instance to FGCom. Since some radio frequencies might be reused across the world, it is essential to set the pilot/controller position correctly to make the FGCom server able to determine the correct voice channel. Position the pilot/controller to the airport having the ICAO code code. The frequency must be written in the format xxx.xxx and must be given in MHz. Set the active radio frequency to frequency. By default, FGCom uses guest as callsign. ![]() Use the callsign callsign during the session. The specified port can be used by an instance of FlightGear to communicate with FGCom and update the pilot position as they fly. By default, FGCom listens on the loopback interface ( 127.0.0.1) on port 16661. Listen on the network interface having the IP address listeninghost, on port port. Options -server= serverĬonnect to the FGCom server server. It is usually not necessary to run fgcom from the command line, as it is already integrated into FlightGear, with the exception of a few specific cases (such as recording ATIS messages or performing a radio check, see the Example section). VoIP client for the FlightGear radio infrastructure Synopsisįgcom Descriptionįgcom is the FlightGear utility used for connecting to multiplayer voice servers. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |